Enter your hours from your logbook. Every answer updates as you change each field.
Today: driving, on-duty and elapsed
Off-duty time in the last 24 hours
Your cycle
Deferral and adverse conditions
Enter your hours to see the verdict.
| Limit | Your hours | Limit | Result |
|---|---|---|---|
A check, not a ruling
This checker follows the federal limits in the table below, but the inspector has the last word on your logbook. Provincial variations, sleeper berth splits and permits can all change the answer for your run.
Your inputs stay in this browser. Nothing is sent to our servers. There is no account to create.
Disclaimer: This tool is provided for general information only. It is not professional advice — verify figures from official sources before acting on them. Hours of service rules vary by province and situation, so check the current regulation before you rely on a single number.
Quick answer: Enter your driving and on-duty hours, your off-duty time and your cycle hours. The tool checks them against the Canadian limits: 13 hours driving, 14 hours on-duty, 10 hours off-duty and your cycle cap. At the defaults in Cycle 1, 9.0 driving hours and 45.0 cycle hours leave 4.0 driving hours and 25.0 cycle hours before rest today.
A legal day on Cycle 1
A driver on Cycle 1, day 4, has driven 9.0 hours and been on duty 10.0 hours, with 11.0 hours elapsed since the last 8 hour rest ended.
Driving has 4.0 hours left, on-duty time has 4.0 hours left and elapsed time has 5.0 hours left. Off-duty time stands at 10.0 hours against 10.0 hours needed.
Cycle 1 has 25.0 hours left from 45.0 hours used, with 3 days left in the 7 day window. A reset takes 36 consecutive hours off-duty.
A driving limit breach
A driver reaches 13.5 driving hours with 14.0 hours on duty and 15.0 hours elapsed. The driver took 8.0 consecutive hours off-duty and 1.0 hour in other blocks.
Driving is 0.5 hours over the 13 hour limit, so the verdict is a violation. Daily off-duty time is also short by 1.0 hours: 9.0 hours taken against 10.0 hours needed.
On-duty time sits exactly at the 14 hour limit, with 0.0 hours left but no overage. The driver must stop now and take at least 8 consecutive hours off-duty.
Cycle 1 has 10.0 hours left from 60.0 hours used, with 1 day left in the window.
The Cycle 2 70 hour gate
A driver on Cycle 2, day 9, has used 68.0 on-duty hours and has not taken 24 consecutive hours off-duty in this cycle. Driving stands at 8.0 hours, on-duty time at 9.0 hours and elapsed time at 10.0 hours.
The day is legal: 5.0 driving hours, 5.0 on-duty hours and 6.0 elapsed hours remain. Cycle 2 has 52.0 hours left from 68.0 hours used, with 5 days left in the 14 day window.
The 24 hour break is due before 2.0 more on-duty hours: at 70.0 hours without that break, the driver must stop. A Cycle 2 reset takes 72 consecutive hours off-duty.
Deferring 2 hours of off-duty time
A driver defers 2.0 hours of off-duty time to tomorrow, driving 12.0 hours with 13.0 hours on duty and 14.0 hours elapsed. The driver took 8.0 consecutive hours off-duty and no other blocks today.
Today needs only 8.0 hours off-duty, so 8.0 hours taken meets the day. Tomorrow needs 12.0 hours off-duty, with the 2.0 deferred hours added to 8 consecutive hours to make 10.0 consecutive hours.
Driving across the two days must stay within 26.0 hours. Today 12.0 hours leaves 14.0 hours of room, while tomorrow still caps at 13.0 driving hours.
Cycle 1 has 40.0 hours left from 30.0 hours used, with 4 days left in the window.
Adverse driving conditions
Snow slows a trip. The driver reaches 14.5 driving hours with 15.5 hours on duty and 17.5 hours elapsed.
Adverse conditions extend the limits to 15.0 driving, 16.0 on-duty and 18.0 elapsed hours, so the day stays legal. Only 0.5 hours remain on each of the three limits.
The extension used is 1.5 hours, so today needs 8.5 hours off-duty instead of 10.0 hours. The driver took 9.0 hours, with 8.0 consecutive hours and 1.0 hour in other blocks.
Without the extension the same day would breach all three daily limits by 1.5 hours each. Cycle 1 has 20.0 hours left from 50.0 hours used.
How the limits work
A Canadian driver south of latitude 60N may drive 13 hours and be on duty 14 hours in a day. No driving is allowed after 16 hours have elapsed since the last period of 8 or more consecutive hours off-duty ended.
Each day needs 10 hours off-duty: 8 consecutive hours plus 2 more hours in blocks of at least 30 minutes each. Blocks shorter than 30 minutes do not count toward the 10 hours.
Cycle 1 caps on-duty time at 70 hours in 7 days, with a reset of 36 consecutive hours off-duty. Cycle 2 caps on-duty time at 120 hours in 14 days, with a reset of 72 consecutive hours off-duty.
Cycle 2 also needs 24 consecutive hours off-duty before the driver reaches 70 hours on duty. Every driver needs 24 consecutive hours off-duty in the preceding 14 days.
Deferral moves up to 2 hours of daily off-duty time to the next day, never from the mandatory 8 consecutive hours. The two days together need at least 20 hours off-duty. The deferred hours join the 8 consecutive hours on day two, while driving across the two days must stay within 26 hours.
Adverse driving conditions extend the driving, on-duty and elapsed limits by up to 2 hours. The extension also shrinks the 2 extra off-duty hours by the time used, never below the 8 consecutive hours.
The tool counts the last 24 hours as the day, since it cannot read your log start time. For adverse conditions it counts the largest of the three extensions as the time needed to finish the trip.
On-duty time always includes driving time, so an on-duty entry below your driving hours counts as your driving hours. Hours round to the nearest tenth, 6 minutes, at entry.
A limit reached exactly means stop, not a breach: at 13.0 driving hours you must rest, but you are not over the limit. The tool flags a breach only when a figure passes its limit.
Daily and cycle limits at a glance
The table lists every limit the tool checks, in hours. All figures are the federal standard south of latitude 60N, as adopted across the provinces with minor variations.
| Limit | Hours |
|---|---|
| Driving in a day | 13 |
| On-duty in a day | 14 |
| Elapsed since last 8 hour rest | 16 |
| Off-duty in a day | 10 |
| Consecutive off-duty | 8 |
| Extra off-duty, blocks of 30 minutes or more | 2 |
| Cycle 1 cap in 7 days | 70 |
| Cycle 1 reset | 36 |
| Cycle 2 cap in 14 days | 120 |
| Cycle 2 70 hour gate break | 24 |
| Cycle 2 reset | 72 |
| 24 hour break in preceding 14 days | 24 |
| Deferral maximum | 2 |
| Adverse extension maximum | 2 |
| Two-day driving cap under deferral | 26 |
| Two-day off-duty minimum under deferral | 20 |
All figures in hours. Adverse conditions extend the driving, on-duty and elapsed limits by up to 2 hours each.
What the tool does not check
Sleeper berth splitting is not modelled: a single driver may split the daily rest into 2 periods of at least 2 hours each, totalling 10 hours, while a team needs 2 periods of at least 4 hours each in the sleeper berth.
Driving north of latitude 60N is not modelled: the limits there are 15 hours driving, 18 hours on-duty and 20 hours elapsed, with an 80 hour gate on Cycle 2. This tool covers the south only.
Oil well service vehicle permits are not modelled: those drivers take 3 periods of at least 24 hours off-duty in any 24 days, with 72 consecutive hours off-duty before returning to a cycle. Deferral is not allowed under those permits.
Ferry crossings of more than 5 hours, emergencies and the 160 km radius log exemption are not modelled either.
A long ferry crossing replaces the 8 consecutive hours only when rest at the terminal, on board and within 25 km of disembarkation totals 8 hours. The tool checks the numbers you enter: it cannot read your logbook or your electronic logging device.
Provinces adopt the national standard with minor variations. This tool models the federal standard, so check your provincial regulation when a provincial rule differs from the figures here.
The defaults behind the tool
Every default below matches the worked example at the top of the page. Change any figure to match your day: the tool rechecks everything as you type.
| Setting | Default | Source |
|---|---|---|
| Driving today | 9.0 hours | Default day |
| On-duty today | 10.0 hours | Default day |
| Elapsed since last rest | 11.0 hours | Default day |
| Consecutive off-duty | 8.0 hours | Default rest |
| Other off-duty blocks | 2.0 hours | Default rest |
| Cycle | Cycle 1 | Default cycle |
| Cycle hours used | 45.0 hours | Default cycle |
| Day in the cycle | Day 4 of 7 | Default cycle |
| 24 hour break in 14 days | Yes | Default answer |
| 24 hour break in this cycle | Yes | Default answer |
| Deferral | None | Default answer |
| Adverse conditions | No | Default answer |
The defaults give 4.0 driving hours left and 25.0 cycle hours left, so the tool opens on a legal result. Your inputs stay in this browser: nothing is sent to our servers.
How to use the Hours of Service Calculator
- Enter your driving, on-duty and elapsed hours for today.
- Enter your longest unbroken off-duty block and your other off-duty blocks of 30 minutes or more.
- Pick your cycle and enter the on-duty hours used and the day you are on.
- Answer the two 24 hour break questions and pick any deferral or adverse conditions.
- Read the verdict: legal or violation, with the hours left on each limit.
- Copy the summary for your records, then verify against the current regulation before you roll.
Frequently asked questions
How many hours can a truck driver drive in Canada?
A driver south of latitude 60N may drive 13 hours in a day and be on duty 14 hours, with no driving after 16 hours elapsed since the last 8 hour rest. Each day also needs 10 hours off-duty: 8 consecutive hours plus 2 hours in blocks of at least 30 minutes.
What is the difference between Cycle 1 and Cycle 2?
Cycle 1 caps on-duty time at 70 hours in 7 days and resets after 36 consecutive hours off-duty. Cycle 2 caps on-duty time at 120 hours in 14 days and resets after 72 consecutive hours off-duty, with a 24 hour break due before 70 hours.
Can I defer off-duty time to the next day?
Yes: up to 2 hours of daily off-duty time may move to the next day, never from the mandatory 8 consecutive hours. The two days together need at least 20 hours off-duty. Driving across the two days must stay within 26 hours.
What happens in bad weather or adverse driving conditions?
Adverse conditions extend the driving, on-duty and elapsed limits by up to 2 hours, so the driving limit rises to 15 hours. The 2 extra off-duty hours shrink by the extension used, while the 8 consecutive hours still apply in full.
How long is the reset after a cycle?
Cycle 1 resets after 36 consecutive hours off-duty. Cycle 2 resets after 72 consecutive hours off-duty. Switching cycles needs the same rest: 36 hours to move from Cycle 1 to Cycle 2, while 72 hours move you from Cycle 2 to Cycle 1.
Do I need to keep my logbook for inspection?
Yes: a driver must carry the records of duty status for the preceding 14 days plus the current day, completed up to the last change of duty status. This tool checks numbers only: it does not replace your logbook or your electronic logging device.
Related Canadian tools
- Cost Per Km Calculator: the full cost per kilometre, with maintenance, tires and fixed costs on top of fuel
- Fuel Cost Calculator: work out fuel cost alone for a Canadian trip, with tank range, fuel stops and diesel against gasoline by province
- Load Profit Calculator: check whether a Canadian load pays, from load pay, fuel, deadhead and costs
- IFTA Calculator Canada: work out your quarterly IFTA fuel tax as a Canadian carrier, by province and state
- Axle Weight Calculator Canada: check steer, tandem, tridem and B-train weights against the provincial limits for all 10 provinces
- HOS Calculator: the US version, with the 14 hour window, 11 hour driving limit and 70 hour week for American hours of service
- Trucking Tools for Canada: the Canada hub, with every Canadian tool in one place
- All Trucking Mind tools: free calculators and checkers for drivers and carriers
Official sources
- Commercial Vehicle Drivers Hours of Service Regulations, SOR/2005-313: the federal hours of service rules this tool follows
- Motor carriers, commercial vehicles and drivers: Transport Canada on the federal rules and the National Safety Code
- BC Commercial Vehicle Safety and Enforcement, National Safety Code Module 3: how one province teaches the daily and cycle rules
This Hours of Service Calculator follows the federal Commercial Vehicle Drivers Hours of Service Regulations and National Safety Code Standard 9, with the federal standard south of latitude 60N. It is guidance only, not a legal ruling on your logbook.
Hours of service rules vary by province and situation. Confirm your figures with the current regulation before you rely on a single number.
Your inputs stay in your browser. Nothing is sent to our servers.